I’m currently planning to switch my Homelab to a cluster of eight Raspberry Pi CM4 modules with two Turing Pi 2 boards. That means a full switch to the aarch64/ARM processor architecture. But not all software supports aarch64 yet. So I went looking for a small x86 machine which doesn’t cost too much, doesn’t take too much space, and doesn’t consume too much power. What I found was the Udoo x86 II Ultra....
Finally, the Netboot Raspberry Pi series concludes with this post. I will be going over both, what figuring out the actual netboot and blogging about it was like. If you’ve followed this series, I’m hoping that you’ve learned a lot more than “just” how to produce an image that can netboot a Raspberry Pi 4. For me, the information on the side, like how the initramfs works in the Linux boot process, was more interesting than then netboot itself....
This is the fifth part of my Raspberry Pi netboot series. The introduction with an overview and links to previous articles can be found here. In this post, we will go over the Ansible playbook I use to provision my Pis. This playbook’s intention is not to fully provision the Pi for use, e.g. it will not set up Nomad or Ceph. It will only prepare the image to netboot and set up my normal Ansible user for my main provisioning Ansible playbooks, to be executed after first boot....
This is the fourth part of the Pi netboot series. Find the previous parts from the introductory article here. In this part of the series, I will go over using a combination of HashiCorp Packer and Ansible to create an Ubuntu Linux image for a netbootable Raspberry Pi, using NFS for the boot partition and a Ceph RBD as the root device. The goal here is to show you how to set up Packer and what configuration is needed to run an Ansible playbook in an aarch64 image on a x86_64 machine....
This is the third part of my Pi netboot series. You can find an overview and links to the other parts in the Pi netboot series overview article. This, to me, is the most interesting article of the entire netboot Pi series. When I started with setting up netbooting, I had no idea how it would work. I had a vague idea that there was a kernel command line parameter, but no idea where it was interpreted....